Drill Press Safety Guidelines 1. Run drill at correct RPM for diameter of drill bit and material. Ask shop personnel for the correct RPM. 2. Always hold work in a vise or clamp to the drill table. 3. Use a correctly ground drill bit for the material being drilled. Shop personnel can help select the correct bit. 4. Use the proper cutting fluid for the material being drilled. Ask the shop staff about the appropriate fluid for the material you are...Baca Selengkapnya »
drill press safety guidelines
Home » Search results for "drill press safety guidelines"
You are browsing the archive related for "drill press safety guidelines"
...ent must be maintained throughout the drilling operation. Care must be taken not to lose control of the portable drill and allow it to be wrenched from the operator’s hands. The larger portable drills can be very dangerous if not held firmly by the operator. If the cutting speed is fixed, the operator must learn to control the feed of the portable drill by applying sufficient pressure for the drill to cut, but not too much pressure as to cause ov...Baca Selengkapnya »
Grinding Safety Guidelines 1. Special training is required before using the surface grinder. Ask shop staff to demonstrate proper use of this tool. 2. Abrasive wheel machinery shall not be operated without the appropriate guards in place. 3. Toolrests on bench or pedestal grinders shall be set no more than 1/16 inch from the wheel. 4. Never use a wheel that has been dropped or received a heavy blow, even though there may be no apparent damage. S...Baca Selengkapnya »
Adapun bentuk dari alat tersebut adalah : Safety Helmet Safety helmet didesain untuk melindungi kepala dari special resisting penetration seperti terantuk dengan pipa, atap dan kemungkinan jatuhnya benda dari atas. Pemakaian safety helmet secara tepat dan benar dapat mengurangi konsekwensi yang mungkin timbul pada saat terjadinya hal-hal yang disebutkan di atas. Cara pemakaian safety helmet yang benar akan memberikan proteksi maksimal bagi kep...Baca Selengkapnya »
Milling Machine Safety Guidelines 1. Work must be clamped securely in a vise and vise clamped tightly to the table, or, work must be clamped securely to the table. 2. Do not take climb milling cuts on the shop’s mills unless instructed to do so. 3. Make sure cutter is rotating in the proper direction before cutting material. 4. Before running machine the spindle should be rotated by hand to make sure it is clear for cutting. 5. Make sure the po...Baca Selengkapnya »
Table Saw Safety Guidelines 1. Special training is required before using the table saw. You may not operate it without permission from the shop supervisor. 2. Stand to one side, never directly in line with, of work being fed through the saw. 3. Use the proper blade for the material and type of cut. Do not use a rip blade for cross cutting, or, a crosscut blade for rip sawing. Do not use a plywood blade for anything but plywood. 4. Inspect the bl...Baca Selengkapnya »
Lathe Safety Guidelines 1. Make sure that the chuck, driveplate, or, faceplate is securely tightened onto the lathe spindle. 2. When removing the chuck, driveplate, or faceplate do not use machine power. 3. When installing the chuck, driveplate, or faceplate do not use machine power. 4. Move the tool bit a safe distance from the collet or chuck when inserting or removing work. 5. Don’t run the machine faster than the proper cutting speed...Baca Selengkapnya »